![G80 Build Kit [Polymer]](https://g80dotcom.s3.us-east-2.amazonaws.com/wp-content/uploads/2026/08/1781084590604-792s91kjugk-7-275x206.png)
![G80 Next Build Kit [Receiver + Grip]](https://g80dotcom.s3.us-east-2.amazonaws.com/wp-content/uploads/2026/08/g80-receiver-grip-kit-275x230.png)
Overview
Pins are small and floors are large. This is the same hardware that ships inside every G80 Unfinished Receiver, sold on its own as a spare set for when one goes missing partway through a build.
Five pieces: two grip pins, a trigger pin, a trigger housing pin, and the slide lock spring. Same parts, same specification, same quantities that come in the box with a receiver.
If you are starting a new build you do not need this. Every G80 Unfinished Receiver already includes one set. Buy this if you have lost a pin, or if you would rather have a spare on the bench before you start than halfway through.
Features
The same five pieces in the same quantities that come with a G80 Unfinished Receiver. Nothing to cross-reference and nothing to measure
Coiled spring pins hold their own position in the frame rather than relying on an interference fit that loosens with use
The G80 uses its own trigger pin, trigger housing pin, and slide lock spring in place of the equivalents in a standard Glock Gen 3 lower parts kit. These are those parts
A build stops dead over one missing pin. Spares cost less than the time spent hunting for the one that rolled under the toolbox
In the Box
- 2x 3mm Grip Pin
- 1x 4mm Trigger Pin
- 1x Trigger Housing Pin
- 1x Slide Lock Spring
G80 Hardware Replacement Set FAQ
No. Every G80 Unfinished Receiver ships with this hardware already in the box, and so does every G80 Build Kit, since the receiver is what carries it. This set exists for builders who have lost a piece or who want a spare on hand before starting.
Two of them are identical 3mm grip pins, which hold the receiver into the grip module. The 4mm trigger pin is the thicker one. The trigger housing pin secures the trigger housing. The small coiled spring is the slide lock spring. If you are replacing something you dropped, measuring the hole it came out of is the fastest way to identify it.
The G80 supplies its own trigger pin, trigger housing pin, and slide lock spring in place of the equivalents in a standard Glock Gen 3 lower parts kit, so those kit parts are not the right substitute for these positions. If you are replacing one of the three, use this set.
No. This is assembly hardware only. Finishing an unfinished receiver takes a jig and the cutting tools that come with it, which are sold separately as the G80 Jig in aluminum or polymer.
No. This hardware is cut for the G80 Unfinished Receiver and the 120R grip module standard it uses. It is not a general purpose pin kit.
